# Parameters can be specified after the module name. # This file contains the names of kernel modules that should be loaded # /etc/modules: kernel modules to load at boot time. You can also load the module boot, if you add It to the /etc/modules file. (Got the info from CPU-Z program, mainboard tab, LPCIO field.) In my case It is the Nuvoton nct6775 module. You are right, the 3.16 kernel is a must.īut you also have to load your mobo's Super I/O chip kernel module as well. I had very similar problem with an A8-7600 & ASUS A88XM-PLUS mobo on UBUNTU 14.04.2. Running 'modprobe it87' then gets the correct temperature details operating.įull credit to this post for having this solution, as well as some additional info in the thread for fixing up the sensor names. etc/modprobe.d/lm_nf options it87 force_id=0x8728 My motherboard uses the ITE it8620e chipset, which is not yet officially supported by the it87 driver. Is there a kernel module I have to load to enable Kaveri support to the K10temp implementation? Running sensors-detect again actually results in it saying it cannot find any temperature probes at all. However, the CPU temperature appears to be the same as before. Regardless, after my upgrade to 14.04.2 I decided to install the utopic HWE, which now sees me running 3.16 kernel, which does have support for Kaveri APUs. In particular, the CPU temperature reported was incorrect: It would read around 0 degrees at idle, then maybe 20 under load. I installed Ubuntu 14.04 when it was released, however it launched with the 3.13 kernel which did not have official support for Kaveri APUs. My machine has an AMD A10-7850K APU which runs very nicely.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |